1961 Microbus

Ken · Post by **Ken** » Thu Dec 31, 2015 5:20 pm

You're painting everything to isn't moving! Cool

Mike Kever Kombi · Post by **Mike Kever Kombi** » Sun Apr 24, 2016 2:08 pm

Plug wires, cap, condenser, points, rotor, and some hoses and this part is done.

Dual Port · Post by **Dual Port** » Sun Apr 24, 2016 5:15 pm

Looks good!

Late FI case, so electric FP? Or gravity feed?

Check your TDC with a piston stop tool, the aluminum pulleys I've checked were nowhere near accurate, not even close.......

Mike Kever Kombi · Post by **Mike Kever Kombi** » Sun Apr 24, 2016 6:49 pm

Dual Port wrote:Looks good!

Check your TDC with a piston stop tool, the aluminum pulleys I've checked were nowhere near accurate, not even close.......

Good tip.

Next arts and crafts project is a run stand. Anyone have a junk trans or bell housing?

Dual Port · Post by **Dual Port** » Sun Apr 24, 2016 7:49 pm

I have trannies but none I want to cut up. Don't make a run stand, it takes up too much real estate while being stored. A chunk of bell for a run adapter is all you need, I cut this with a Sawzall:

Get a 2 gallon outboard motor fuel tank and a battery and you're in business.

Mike Kever Kombi · Post by **Mike Kever Kombi** » Thu Apr 28, 2016 8:16 pm

Still at it
1

: Started with this piece of bent metal screwed to hinge

2

: Missing piece of og metal

3

: New piece of 22g sheet spotted to 18g spreader and nuts tacked

4

: Welded in

5

: Some duraglass and it's a wrap

LEAKOIL Forum

1961 Microbus

Re: 1961 Microbus

Re: 1961 Microbus

Re: 1961 Microbus

Re: 1961 Microbus

Re: 1961 Microbus

Re: 1961 Microbus