1971 Early Bay Panel

[Busjunky]

Made a useable seam out of the corner. Klokkerholm boo yay!!

[Busjunky]

Corners in and i replaced that wall while i was at it.

[Busjunky]

Then i did the long side rocker. The cheap panels do not have the seam in them so i made it by hand.

[Busjunky]

I cut it into two pieces and made 90 degree bends in it to create the seam.

[Busjunky]

Then i recreated the panel wall seams by using a chisel to offset the sheet steel. I cut those slots in it so it wouldn't bind when i bent the radius.

[Busjunky]

I rebuilt that B pillar by hand too. Here it was all fitted in. Looks alot better now that finished it up. This was done awhile back.

[Busjunky]

Go the driver side corner removed and the rear wheel well area. I made that corner the same way as the other side.

[Busjunky]

I made that lower fender piece by hand. Re-werked klokkerholm corner. I also deleted the reverse lights.

[Busjunky]

Replaced the slider track. Pita.

[Busjunky]

I decided to slam the piss out this thing. So i had to tub the rear wheel wells. Well the gas tank was in the way so i had to move it to the upper left hand corner.