Page 6 of 7
Re: ed's 67 deluxe
Posted: Tue Aug 26, 2014 12:11 pm
by Dual Port
heyed67 wrote:
I got 18.6 mpg @ average speed of 55
I got 24.8 @ 55mph going to Columbus and back.......

Re: ed's 67 deluxe
Posted: Tue Aug 26, 2014 1:37 pm
by Mike Kever Kombi
Bumpers add more wind resistance

Re: ed's 67 deluxe
Posted: Tue Aug 26, 2014 3:12 pm
by Dual Port
Mine has bumpers.

Re: ed's 67 deluxe
Posted: Tue Aug 26, 2014 7:34 pm
by Mike Kever Kombi
Dual Port wrote:Mine has bumpers.

+1 for bumpers
Time for an avi update
Re: ed's 67 deluxe
Posted: Fri Apr 17, 2015 10:22 am
by heyed67
I've restored a short mid seat frame and re wound about 50 coil seat springs..I do not advise doing this. rusty crusty springs have sanded my finger prints right off my fingers.my seat back spring frame is thrashed any one have any suggestions on finding a Donner to rob parts from. Or bare naked short seat back that is good?
Re: ed's 67 deluxe
Posted: Mon Apr 20, 2015 9:50 am
by John
How is that five dollar carb werking out?
Re: ed's 67 deluxe
Posted: Tue Aug 04, 2015 9:35 pm
by heyed67
Bus has been down for 5 days feels like its been a month.

clutch release bearing spring clip pop'ed off and caused a few problems. New clutch in..hopefully be back on the road In the next day or so.. note to self( DO NOT MAKE ANOTHER CLUTCH CLIP OUT OF A COATHANGER EVER AGAIN).......
Re: ed's 67 deluxe
Posted: Wed Aug 05, 2015 11:14 am
by TRL
Haha. Im not sure i would admit that ED

Re: ed's 67 deluxe
Posted: Thu Aug 06, 2015 10:03 pm
by Frankinbus
heyed you going to volksfest sat ? if not and you still need armrests let me know ill look for some. tim
Re: ed's 67 deluxe
Posted: Sat Apr 16, 2016 8:50 pm
by heyed67
Well I did have a broken trans mount at nosecone.symptoms were tight shifter when I turned right and freed up when I turned left. Also heard cluncking between reverse and 1st gear.I fixed it today.....I also found 95 percent restriction in my heatriser tube..brakeparts cleaner and 2 foot peice of emergency brake cable fixed that problem..also cleaned up and painted engine tin and intake parts.
